How to install power bank-712 for car.
Caution before installing  

1. Power bank product is for car only which is used 12 Volt batteries.
    (passenger car, RV, SUV, van, pickup truck)

    Some of large trucks, bus using 24V batteries are not right to use.

2. Products take out after testing. (LED ON is normal)

3. To be safe, install this by using insulated gloves.

Changing polarity is caused the failure, so pay attention to installation.
Red covered cable is (+), and black covered one is (-).


Installation sequence

STEP 1 .
Turn the ignition off then pull the parking brake after parking in a safe place.

STEP 2 .
Put the gear on the (P) parking or (N) neutral.

STEP 3.
 Check the battery location then make sure the +/- polarity terminal.

STEP 4.
 Clean up the dirt at the battery terminal or screw thread before installing.

STEP 5.

 Connect the red covered terminal to battery (+).

STEP 6.
Connect the black covered terminal to battery (-).
It could lead to spark when it installs, that¡¯s normal condition.

STEP 7.
 If it¡¯s connected normally, LED turns on.

STEP 8. Clean up the top of battery which is free from interfere each part.

STEP 9. Fix the power bank by using Velcro tape.

STEP 10.
 Be idling for a few minutes after installing.

 

 
Caution after installing

1. If car is not moving more than 6 months separate power bank from battery for the life time.

2. Power bank has charged plenty of electronic power though diving from battery.
Cause not to touch red and black covered terminals until LED OFF.

3. Free after service (A/S) for one year against failure parts.
If fault is cause to users, it should be paid for repairing service even if free A/S period.